![]() Upgrading Flmsg will require changing the path to use the newer version.Open with flmsg and Open in browser checked under Reception of flmsg files. It is important to have: Enabled checked under NBEMS data file interface. The remaining settings are the default settings. Under Reception of flmsg files, uncheck Transfer direct to executing flmsg (this option is not in versions prior to 3.23.0). It’s not proper etiquette to send a CW ID after every transmission in the digital portion of the low bands (HF). Enabling CW ID will properly ID your station after each transmission. If operating NBEMS and digital sideband with the same station, take some time to go through the list of CW ID modes and disable PSK and any modes that will be used on HF, leaving MT63/FM modes enabled.Under CW Postamble ID, check Transmit callsign. When using NBEMS on FM (this is non-standard on side band), click CW in the second row of tabs. Leave this value at 0 for HF/sideband operation and/or remember to turn it off if the station will operate FM and sideband with the same setup.There is a half-second delay between the Pre-Signal tone and RsID that will unkey the radio. When using devices like the SignaLink, set the delay to the 12 o’clock position or higher.This will ensure the RsID is not cut off while the repeater and receiving stations are starting to receive the transmitted signal. The Pre-Signal tone will bring up the repeater and allow receiving stations time to start receiving the signal before the RsID is sent.Under Pre-Signal Tone, for an FM repeater net select a time between 3 and 5 seconds. A PSK31 (31Hz) RSID (172Hz) takes up 5.5 times the bandwidth! Other nearby PSK31 users will not be very happy with you transmitting a PSK31 RSID.To control which modes transmit an RSID click Configure, IDs, click the RsID tab, and click Transmit modes. PSK31 is a very popular mode so no RSIDs are used. The RSID can take up more bandwidth than the digital mode and is not used on many common modes. It is possible to decode the RSID and not decode data due to a weak signal. On reception of an RSID, the mode is changed. RxID and TxID encode and decode the Reed-Solomon Identification (RSID) for identifying digital modes. ![]() The frequency can be fine-tuned with the “adjust cursor frequency” adjustment. MT63-2000L (or MT63-2KL) is most often used by the net and NBEMS.įldigi will now show “MT63-2KL” in the lower left status line.Blocking this firewall exception will not allow programs in the suite to communicate and result in undesired operation. Fldigi sets up a local server to communicate with other programs.If you are a standard user, you will need the administrator password. SignaLink USB users do not need to set these options.If the transceiver requires keying control, select it using one of the control methods and configure those options. ![]() See the “Calibration” section at the beginning of this document for methods to calibrate Fldigi. Sound card calibration is recommended regardless of mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |